diff --git a/diylc/diylc-core/src/main/resources/update.xml b/diylc/diylc-core/src/main/resources/update.xml index 90098b29..5fce79d8 100644 --- a/diylc/diylc-core/src/main/resources/update.xml +++ b/diylc/diylc-core/src/main/resources/update.xml @@ -664,51 +664,15 @@ 2026-10-17 00:00:00.000 CET - - - IMPROVEMENT - Rotating and mirroring the selection with 'Sticky Points' enabled now keeps the circuit connected, the same way moving it does - wires and leads stuck to the selection stay attached to their pins, and other rigid components stuck to it are rotated or mirrored along with it - - - IMPROVEMENT - Improved sorting of switching combinations in 'Analyze Guitar Diagrams' tool - - - BUG_FIX - Fixed Guitar Analyzer logic that merges switching configuration that produce the same outcome; in some cases it would remove switches from the list when it shouldn't - - - BUG_FIX - Gerber export on computers set to a language that uses a decimal comma (e.g. German, French, Serbian) produced files in which drill holes, pads and traces had the wrong size - a 0.8mm hole came out as 0mm and traces and the board outline had no width, so the files could not be used for fabrication - - - BUG_FIX - Zooming out until the drawing is smaller than the window made the toolbar above the canvas grow taller and squeeze the canvas; the toolbar now keeps its height at every zoom level - - - BUG_FIX - Fixed a bug that makes it impossible to clear a property with dynamic values, e.g. 'Selected Position' of a switch - - - BUG_FIX - Fixed a bug that makes 'Selected Position' list sometimes shows wrong values - - - https://github.com/bancika/diy-layout-creator/releases - - - - 6 - 10 - 0 - - 2026-10-19 00:00:00.000 CET - NEW_FEATURE AI Assistant can actively participate in circuit design, make changes to the project and designs circuits from scratch + + IMPROVEMENT + Rotating and mirroring the selection with 'Sticky Points' enabled now keeps the circuit connected, the same way moving it does - wires and leads stuck to the selection stay attached to their pins, and other rigid components stuck to it are rotated or mirrored along with it + IMPROVEMENT Allow active position selection for 'Rotary Switch Sealed', 'DIP Switch', 'Latching Switch Symbol', 'LP Switch', 'S1 Switch', allowing for more accurate circuit analysis and debugging @@ -737,6 +701,14 @@ BUG_FIX 'Analyze Guitar Diagrams' ignored 'Stingray Bass Pickup', so a diagram built around it was reported as having no pickups connected to the output jack, and its coils were left out of the hum-cancelling and phase checks + + BUG_FIX + Gerber export on computers set to a language that uses a decimal comma (e.g. German, French, Serbian) produced files in which drill holes, pads and traces had the wrong size - a 0.8mm hole came out as 0mm and traces and the board outline had no width, so the files could not be used for fabrication + + + BUG_FIX + Zooming out until the drawing is smaller than the window made the toolbar above the canvas grow taller and squeeze the canvas; the toolbar now keeps its height at every zoom level + https://github.com/bancika/diy-layout-creator/releases